#Gardening
en
31.7K Members
Commons
Cards
Talks
Q&A
Members
Popular
Updated
Grow Your Own Avocado Tree From Seed
Planting your own avocado tree is a lot easier than you think. You don't need a lot of materials, space, or time. This project is great for people of all ages and can grow from your outdoor garden or inside your home. Here's how to get started: Directions: 1. Take a ripe avocado and cut it into 2 halves. Remove the seed from the center, rinse off with fresh water, and make sure there is no fruit on it. Let the seed dry completely. 2. Push 3-4 toothpicks inside the seed from all sides towards the middle. Place in a full glass of water so the pointy end of the seed faces upward, while the round part is in the water by an inch. 3. Keep the glass in a semi warm climate controlled place (away from direct sunlight). Leave for 4-6 weeks and check regularly to see if additional water needs to be added. Note: The seed will sprout a stem and roots. Once you see the stem is 6 inches long, cut it down to 3 inches. The stem will continue to grow and you will start to notice some leaves. 4. Take out the seed from the glass and move it to a large pot 3 ft. wide and 3 ft. deep. Add some rich fertile soil and compost to the pot and plant the seed. Note: The root of the seed should be pushed inside the soil about 1-3 inches, while the top half of the seed should remain outside the pot. 5. Place the pot where it can get good sunlight, water, and air. The soil should remain moist, but not completely saturated. Note: It's helpful to use a pot with good drainage. Pinch the top leaves of the plant every time the stem length increases by 6 inches to help the growth of the plant. *It's beneficial to start planting in the Spring. Also, if you don't want to plant your avocado tree in the garden, make sure to take your plant outside on a daily basis for sunlight and fresh air. It will take about 7=15 years for the tree to yield fruit, so be patient!
DIY Magnetic Tin Terrarium
- Gravel - Air plants, cactus or succulents - Moss - spray paint - magnetic metal tins - Dremel tool - painter’s tape - E6000 glue Cover your tins with painter’s tape before you begin spray painting the inside of them. Spray tins with 3-4 light coats until they have are opaque in solid white. While your tins are drying, remove the acrylic top from all lids by putting a small amount of pressure with your hands to pop them off. Measure the diameter and mark a line with a permanent marker. Using the diamond cutter tip of your Dremel tool, slice all acrylic lids in halves (you can also try different shapes or drill holes). Lightly sand the edges using a sander tip of your Dremel tool. Place acrylic tops back in the metal frame of the caps and glue both pieces. We also recommend dabbing the edges of the tins with a q-tip with glue to seal the lids to prevent the weight from the gravel popping out of the containers. It took one wall terrarium to splash gravel all over the floor for us to figure that out :) Once your tins are dry from spray paint, remove tape and wash tins with water and soap. Close all tins, now with open front lids. Add gravel, misty moss and air plants. If you prefer building a closed terrarium and skipping cutting the lids, you will need activated charcoal, which can be found in the aquarium section at any pet store. Air plants won’t work well in closed containers, so you may want to switch to ferns and small leafy plants.