Prepare for your Cisco 350-501 certification exam: with free Cisco 350-501 exam questions, Cisco 350-501 dumps!
[FREE Ddownload] Latest Cisco 350-501 Exam Dumps PDF
Cisco 350-501 Exam Questions & Answers
Free share Part of new exam questions | Cisco 350-501
QUESTION 1

Refer to the exhibit. Which command is used to complete this configuration for QoS class-based marking?
A. PE-A(config-pmap-c)#set dscp ef
B. PE-A(config-pmap-c)#priority
C. PE-A(config-pmap-c)#random-detect
D. PE-A(config-pmap-c)#fair-queue
Correct Answer: A
QUESTION 2
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
A. flowspec address-family ipv4 local-install interface-all
B. flowspec address-family ipv4 install interface-all local
C. flowspec address-family ipv4 install interface-all
D. flowspec address-family ipv4 local-install all-interface
Correct Answer: A
QUESTION 3

Refer to the exhibit. Which statement describes this configuration?
A. Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only.
B. Router 1 can be remotely managed by the CLI using Telnet.
C. Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill
session.
D. Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified
before committing the configuration.
Correct Answer: D
QUESTION 4

Refer to the exhibit. In which way does router R1 operate differently than router R2?
A. R1 sends LSA types 5 and 7, while R2 sends type 1, 2, and 7 LSAs.
B. R1 sends LSA type 2 only, while R2 sends type 1 and type 7 LSAs.
C. R1 sends LSA type 2 only and R2 sends LSA type 1 only.
D. R1 sends LSA types 1 and 2, while R2 sends type 1,2, and 7 LSAs.
Correct Answer: D
QUESTION 5
DRAG DROP
Drag and drop the functionalities from the left onto the correct target fields on the right.
Select and Place:

QUESTION 6

Refer to the exhibit. When implementing an LDP protocol, an engineer experienced an issue between two directly
connected routers and noticed that no LDP neighbor exists for 1.1.1.1. Which factor should be the reason for this
situation?
A. LDP needs to be enabled on the R2 loopback interface.
B. LDP needs to be enabled on the R2 physical interface.
C. R2 does not see any hellos from R1.
D. R2 sees the wrong type of hellos from R1.
Correct Answer: B
QUESTION 7

Refer to the exhibit. Which statement about the neighbor statements for 192.168.1.1 is true?
A. The router sends BGP labels for its prefixes to this peer.
B. The router must have TDP configured for the send-label command to operate.
C. The neighbor router receives at least four labels from this router.
D. The router sends only a label for the prefix for Loopback0.
Correct Answer: A
QUESTION 8
A service provider has a requirement to deliver WAN gateway functionality to multi- tenant, provider-hosted clouds.
Which cisco platform meets this requirement?
A. Cisco ASR 9000 series
B. Cisco NX-OS
C. Cisco ASR 1000 Series
D. Cisco CSR 1000v
E. Cisco CRS series
Correct Answer: D
QUESTION 9
What is the maximum capacity of a single Cisco CRS-1?
A. 64 Tb/s
B. 78 Tb/s
C. 92 Tb/s
D. 106 Tb/s
E. 128 Tb/s
Correct Answer: C
QUESTION 10

Refer to the exhibit. P3 and PE4 are at the edge of the service provider core and serve as ABR routers. Aggregation
areas are on either side of the core. Which statement about the architecture is true?
A. To support seamless MPLS, the BGP route reflector feature must be disabled.
B. If each area is running its own IGP, BGP must provide an end-to-end MPLS LSP.
C. If each area is running its own IGP, the ABR routers must redistribute the IGP routing table into BGP.
D. To support seamless MPLS, TDP must be used as the label protocol.
Correct Answer: B
More NEW Cisco 350-501 Exam Questions Answers From
More NEW Cisco 350-501 Exam Dumps From
Pass4itsure Cisco dumps discount code 2021
Please read the picture carefully to get 15% off! The latest discount code "Cisco" is provided below.
