This is such a great idea: sometimes, we want to add a vintage-y piece to our garden, but can't find the right one. It's possible to make your own weathered looking sign with this tutorial! Thanks to Elegant Nest for the pictures, and Miss Mustard Seed for the tutorial tips! What you’ll need: 12” wide pine board cut to desired length Acrylic craft paint (at least three colors) 2 ½” sash brush 1” artist brush, 1.0 liner brush, ½” angled shader Computer Printer and printer paper Scissors Tape Graphite transfer paper Ballpoint pen 80 grit sand paper Dark brown soft furniture wax Round brush or cotton cloth Clean cotton cloth Drill with driver bits Tape measure or ruler 2 D-ring hangers Hammer and nails How to do it: 1. Cut a piece of 12” wide pine board to desired length or use a piece of scrap lumber. If wood is new, hit it with a hammer and scratch it with nails to rough it up. Using a 2 ½” sash brush, paint the board in desired color. It is best to use a flat or matte acrylic or milk paint. Allow paint to dry. 2. Use a word processing program on the computer to design text for the sign. Sizing it to fit on the board may take some trial and error, so print only one or two letters at a time until the right font size is determined. Print the letters. For smaller letters and words, cut out and tape them together. Place graphite transfer paper under the lettering and trace outline with a ballpoint pen. Make sure lettering is level on the sign before tracing. One piece of transfer paper can be used repeatedly for entire sign. 3. Use a 1” wash brush to paint large letters or a ½” angled shader for smaller letters. If desired, paint a border on the sign as well. 4. Choose a darker, coordinating color to paint an outline and shadow around letters. This makes the letters stand out and gives the sign a three dimensional appearance. Allow paint to completely dry. 5. Sand entire sign with 80 grit sandpaper to distress lettering and paint. Allow wood to show through in some areas. Wipe away dust with a cloth. 6. Use a round brush or soft cloth to apply a dark brown furniture wax in a thin layer to entire surface of sign. The wax will settle in the imperfections in the wood, giving the sign an authentically aged look. Allow wax to dry for 3-5 minutes, then buff to a shine with a clean cloth. 7. Turn sign over and measure approximately 2” in and down on each corner. Make a mark with a pencil or pen. Drill a pilot hole for the D-ring hanger screw on the mark. Attach D-ring hangers to back of the sign using screws. Hang sign on nails. For heavy or large signs, locate a stud or use anchors to hang securely. Always use caution and wear safety glasses when using power tools. And that's it!