What you’ll need: -Any pair of flats, canvas shoes, or loafers -Mod Podge (available at craft stores) -Glitter (gold, silver, etc.) -Newspaper & a plate or bowl -Foam brushes or paint brushes -Clear coat spray paint (to make sure the glitter stays on!) First, you’ll want to stuff newspaper down into the shoe so that no glitter or glue gets inside! I removed the laces from my shoes also, just to make sure they didn’t get all gunked up. Pour some of the mod podge onto a plate or into a bowl. I used a paper plate because they are disposable and it was easier to use a flat surface to get a thin coating of the mix. Next, you’ll want to pour some glitter into the mod podge. You’ll want about half as much glitter as there is mod podge, because you don’t want the mix to be too thick. Mix the glitter and mod podge together using one of your foam brushes. Then get ready to paint your shoes! Paint a thin coat of the mix onto the shoe. Make sure that it is smooth and not too chunky because it will dry that way! I didn’t want to paint the whole shoe, so I only painted the front and the back, leaving the middle white. Once you have the mod podge mix on the shoe, you’ll want to pour a SMALL amount of glitter onto the spots you just painted. This just gives the shoe a little extra glitter, and makes sure that there are no white spots. When you’re finished adding the glitter to the shoes, you’ll want to clean off any extra glitter that is on the shoe because you don’t want it to be stuck there when you spray the clear coat. I used a damp paper towel to clean off the edges and the bottom. Last but not least, spray your shoes with a clear coat spray paint. This makes sure that the glitter stays shiny and does not fall off the shoes. Make sure to read the directions on the can and do not get it on your skin or in your eyes. When this is done, you’ll want the shoes to sit and dry overnight to make sure that they are ready to wear.