alise
10,000+ Views

Personalized Phrase Bracelet

Remember those BFF (Best Friend Forever) Bracelets you use to buy and share with you friends? This is a grown-up version where you can personalize with an adjective or a name. Perfect for a holiday gift! Try it out and let me know how it goes. Supplies: - Flat leather (10mm x 2mm) or oval leather (10mm x 6mm) - Letter sliders (I love this font in either 10mm x 2mm or 10mm x 6mm, and they sell hashtags too!) - Magnetic clasp (10mm x 2mm or 10mm x 6mm) - Jewelry glue Directions: Cut one side of your leather into a point like the front of an arrow. Slide your phrase letters onto the leather strap. Trim your arrow shaped for a straight cut. Take one of your magnetic clasps, add a small drop of glue into the opening, and quickly place your leather end into the opening. Place the leather around your wrist to determine the length of the bracelet. Cut your leather to size and attach the other side of the clasp. Flip the bracelet over and, starting with the middle letter, place a drop of glue where that letter should go. Slide your letter over onto the glue and let it sit for a moment until the glue starts to set. Repeat the process with the other letters until they are all glued in place.
2 Comments
Suggested
Recent
I want to make one for myself!
I actually like the "name" tag idea. I'll have to make it for my sisters!
Cards you may also be interested in
DIY Macrame Bracelet
You’ll need: 4 yards of 0.5mm chinese knotting cord a connector or charm an embroidery needle a pair of scissors flat nose pliers (optional) a lighter (optional) Start by cutting the knotting cord into two 30 inch, two 20 inch and one 10 inch lengths. Fold the 20 inch piece in half, pull the loop through the ring, fold it over the ring, and pull the rest of the cord through the loop. Repeat the step on the other side of the ring. These strands will be anchored and remain stationary. Center the 30 inch cord under the two middle strands. Fold the right cord over the middle strands and under the left cord. Pull the left cord under the right and middle strands and through the loop on the right side. Pull tightly and slide the knot up to the top. Finish the 2nd half of the square knot by folding the left cord over the middle strands and under the right cord. Pull the right cord under the left and middle strands and through the loop on the left side. Pull tightly and repeat the steps – left, right, left, right . . . Continue knotting until the desired length is reached. Keep in mind that the clasp will take up approximately half an inch. To finish the knots, thread one of the cords onto a needle and sew up the center of 3-4 knots along the backside. Pliers will help pull the needle through the tight knots. Repeat the same step on the other cord. After sewing up both knotting cords, trim away any excess. Save the scraps and melt the tips with a lighter to seal it for extra hold. Repeat the same exact step on the second half of the bracelet. To make a sliding closure, shape the bracelet into a circle and overlap the middle strands. Use scraps to temporarily tie the cords together at each end. Take the 10 inch cord and center it under the strands. Start tying square knots exactly the same way the bracelet was executed. Stop at about half an inch and sew the knotting cords into the backside of the closure. Remove the temporary ties. The two sets of middle strands are now the adjustable ties of the bracelet. Adjust to fit the wrist and tie each end into knots. Trim away any excess. Your adjustable knotted bracelets are finished!! xx